PEAK XOOPS - Upgrade issue 
Upgrade issue
- You cannot open a new topic into this forum
- Guests cannot post into this forum
Previous post
-
Next post
|
Parent
-
Children.1
|
Posted on 2005/9/6 19:06
Dave_L
From: Virginia, USA
Posts: 35
From: Virginia, USA
Posts: 35
I had a minor problem upgrading Protector from 2.40RC2 to 2.52 on XOOPS 2.2.
After putting the 2.52 files in place, I wasn't able to access the XOOPS admin page to upgrade the module; I got logged out of XOOPS whenever I tried it.
I solved the problem by manually disabling the Protector module in the database (in the xoops_config table, change global_disabled to "1") using phpMyAdmin. Then I was able to access the admin page, upgrade the module, and re-enable the module.
Editing mainfile.php to temporarily remove the precheck/postcheck would probably have worked too.
Just a heads up for anyone who runs into the same problem. You may want to disable the Protector module before attempting to upgrade it.
After putting the 2.52 files in place, I wasn't able to access the XOOPS admin page to upgrade the module; I got logged out of XOOPS whenever I tried it.
I solved the problem by manually disabling the Protector module in the database (in the xoops_config table, change global_disabled to "1") using phpMyAdmin. Then I was able to access the admin page, upgrade the module, and re-enable the module.
Editing mainfile.php to temporarily remove the precheck/postcheck would probably have worked too.
Just a heads up for anyone who runs into the same problem. You may want to disable the Protector module before attempting to upgrade it.
Votes:2
Average:5.00
Previous post
-
Next post
|
Parent
-
No child
|
Posted on 2005/9/8 5:48
GIJOE
Posts: 4110
Posts: 4110
hi Dave.
Thank you for teaching a good tip.
Certainly, this problem can occur in upgrading process.
I'll add the notice.
Thank you for teaching a good tip.
Certainly, this problem can occur in upgrading process.
I'll add the notice.
Votes:1
Average:0.00
Login